VESTIL MDS-96-SM Smoker Shelter, Multi Duty, 95-1/2 x 120 x 90-1/16 Inch Size, Blue/White, Steel

Compatible Accessories:

• Vestil AS-125 and AS-125-4PK Anchor Bolts: They are required for installation in concrete.

Standards and Approvals:

• OSHA

Frequently Asked Questions:

Q. Where should the smoking shelter be located?

A. Smoking shelters must be located far away from public buildings and commercial areas where smoke could not drift into smoke-free zones.

Q. How much snow load can this unit hold?

A. Vestil MDS-96-SM smoker shelter can hold up to 45 lb/sq.ft snow load for maximum protection.

Q. What is the snow holding capacity of this shelter?

A. The steel roof of the shelter can hold snow up to 45 lb/sq.ft.

Q. What tools are required for assembling this shelter?

A.

• Two 9/16 inch wrenches
• 5/16 inch driver for cordless or corded drill
• Bubble level
• 10 ft tape measure
• Vice-grip

Q. How to assemble this Vestil MDS-96-BK bicycle storage shelter?

A.

• Lay out wall supports. The mounting plate's longer sides must be toed-in towards one another.
• Before you begin putting the self-tapping screws (that hold the side walls) to the wall supports, measure 4 inches up from the bottom of the mounting pads.
• Make sure that the screws securing the siding to the frame are facing the bottom side of the wall while installing the centre angle iron rail on the side walls & back wall.
• Using a 4-inch spacer, elevate the back wall panel and attach it to the wall supports.
• Install at least 1-piece bolt with 2 pieces of 3/8 inch washers per support on each side of the mounting pads.
• Insert 1 piece of a 9-inch long spacer for both sides.
• From the front of the shed, lift the opposite side of the roof panel and install it.
• Install bolts and nuts to each side of the roof along with washers (above & below the mounting pad).
• To secure the shed to the ground, use the mount pad holes.
• With 1 self-tapping screw, attach the smoker's rest to the middle back frame of the shed, and repeat on the other side.
• Place the smoker's shield in the shed's front door.
• Use 2 self-tapping screws to secure the top of the smoker's shield to the shed.