TRICO 30084 Constant Level Oiler, Type EHB, 4 oz. Capacity, 2-5/16 Inch Size, Plastic Reservoir

Working Mechanism:

• After proper installation, whenever the oil level in the attached system / equipment drops below a certain point, the liquid seal on the unit's reservoir spout breaks and allows air to enter through the air vent into the oil reservoir. This allows the oil to flow from the reservoir into the equipment and maintain the required lubrication.
• The liquid seal reestablishes itself after the depleted oil self-levels according to this constant level oiler.

Compatible Accessories:

• Trico Oiler Wire Guards: These wire guards protect the reservoir of this oiler from potential accidents.
• Trico 36470 Opto Laser Level: These levelling tools are used to accurately set / level this constant level oiler on the system.

Standards and Approvals:

• ISO 9001:2015
• ISO / IEC 17025:2017
• ASTM

Frequently Asked Questions:

Q. What is the construction material of this Trico 30084 Opto-Matic constant level oiler?

A. This constant level oiler has a transparent butyrate plastic reservoir having a 4-ounce capacity. It further has a lower casting having die-cast zinc construction with bright zinc plating. The unit's internal parts are made of zinc-plated steel.

Q. How is this Trico 30084 Opto-Matic oiler installed on equipment?

A. Trico 30084 Opto-Matic oiler has 1/4 inch NPT connections for easy installation on the equipment.

Q. How to install this Trico 30084 Opto-Matic oiler?

A.

• Before installing, determine the shaft rotation direction.
• Install the oiler on the side of the equipment facing the direction of shaft rotation to prevent misfeeding of the oiler.
• Determine the equipment's proper oil level. Loosen the set screw and remove the reservoir.
• Connect the lower casting of this unit to the bearing chamber using side or bottom connections. Level it properly & mark the desired oil level.
• Measure the distance between the unit and the top edge of the spout angle. Mark this distance above the line made in the above step as X.
• Fill the equipment bearing chamber through the unit's lower casting until the oil level reaches the desired level mark.
• Fill 2/3 of the reservoir with the recommended oil using a funnel. Invert it over the lower casting. Insert the reservoir assembly till its bottom edge reaches the X mark.
• Tighten the set screws on the reservoir assembly and start the process to check for the proper functioning of the oiler.