TRICO 30082 Constant Level Oiler, Type EHB, 2 oz. Capacity, 1-15/16 Inch Size, Plastic Reservoir

Working Mechanism:

• Before installing, determine the shaft rotation direction.
• Install the oiler on the side of the equipment facing the direction of shaft rotation to prevent misfeeding of the oiler.
• Determine the equipment's proper oil level. Loosen the set screw and remove the reservoir.
• Connect the lower casting of this unit to the bearing chamber using side or bottom connections. Level it properly & mark the desired oil level.
• Measure the distance between the unit and the top edge of the spout angle. Mark this distance above the line made in the above step as X.
• Fill the equipment bearing chamber through the unit's lower casting until the oil level reaches the desired level mark.
• Fill 2/3 of the reservoir using the recommended oil using a funnel. Invert it over the lower casting. Insert the reservoir assembly till its bottom edge reaches the X mark.
• Tighten the set screws on the reservoir assembly and start up the process to check for the proper functioning of the oiler.
• Whenever the oil level in the attached system / equipment drops below a certain point, the liquid seal on the unit's reservoir spout breaks and allows air to enter through the air vent into the oil reservoir. This allows the oil to flow from the reservoir into the equipment and maintain the required lubrication.
• The liquid seal reestablishes itself after the depleted oil self-levels according to this constant level oiler.

Compatible Accessories:

• Trico Oiler Replacement Parts: Raptor Supplies offers replacement parts & accessories like reservoirs, upper castings, lower castings, set screws & pipe plugs for replacing the old, worn-out or faulty parts in this Opto-Matic oiler.
• Trico Oiler Wire Guards: These wire guards fit over the reservoir of this oiler to protect it from potential accidents.
• Trico 36470 Opto Laser Level: These tools help users to precisely set / level this Opto-Matic oiler on the system if improperly installed.

Standards and Approvals:

• ISO 9001:2015
• ISO / IEC 17025:2017
• ASTM

Frequently Asked Questions:

Q. What is this Trico 30082 Opto-Matic constant level oiler made of?

A. This constant level oiler features a transparent butyrate plastic reservoir having a 2-ounce capacity and a lower casting made of die-cast zinc with bright zinc plating. Its internal parts have zinc-plated steel construction.

Q. How is this Trico 30082 Opto-Matic oiler installed on equipment?

A. Trico 30082 Opto-Matic oiler has 1/4 inch NPT connections for easy installation on the equipment.

Q. What is the maximum temperature to operate this Trico 30082 Opto-Matic oiler?

A. This Opto-Matic oiler can operate at a continuous temperature of 165 degrees F.