TRICO 30074 Constant Level Oiler, Type EH, 4 oz. Capacity, 2-5/16 Inch Size, Plastic Reservoir

Working Mechanism:

• Before installing, determine the direction of the shaft rotation .
• Install the oiler on the side of the equipment facing the direction of shaft rotation to prevent misfeeding.
• Determine equipment's proper oil level. Loosen the set screw and remove the reservoir.
• Connect the lower casting of this unit to the bearing chamber using side or bottom connections. Level it properly & mark the desired oil level.
• Measure the distance between the unit and the top edge of the spout angle. Mark this distance above the line made in the above step as X.
• Fill the equipment bearing chamber through the unit's lower casting until the oil level reaches the desired level mark.
• Fill 2/3 of the reservoir using the recommended oil using a funnel. Place a thumb over the reservoir spout & invert it over the lower casting. Insert the reservoir assembly till its bottom edge reaches the X mark.
• Tighten the set screws on the reservoir assembly and start the process to check for the proper functioning of the oiler.
• If the oil level drops below a certain point in a system, the liquid seal on the spout breaks inside the constant-level oiler. Then air enters through the air vent into the oil reservoir, allowing the fluid to flow from the reservoir into the equipment.
• The liquid seal reestablishes itself after the depleted oil self-levels according to the constant level oilers.

Compatible Accessories:

• Trico Oiler Wire Guards: These wire guards fit over the oiler's reservoir to prevent potential accidents.
• Trico 36470 Opto Laser Level: These tools inspect & accurately set / level this Opto-Matic oiler if improperly installed or used.

Standards and Approvals:

• ISO 9001:2015
• ISO / IEC 17025:2017
• ASTM

Frequently Asked Questions:

Q. What is the reservoir capacity of this Trico 30074 Opto-Matic oiler?

A. Trico 30074 Opto-Matic oiler's reservoir has a capacity of 4 ounces.

Q. What is the maximum temperature to operate this Trico 30074 Opto-Matic oiler?

A. This Opto-Matic oiler can operate at a continuous temperature of 165 degrees F.

Q. What is the construction material of this Opto-Matic constant level oiler?

A. This Trico 30074 Opto-Matic oiler's lower casting is made of die-cast zinc with bright zinc plating, whereas its internal parts have zinc-plated steel construction.