DYNABRADE 52431 Offset Air Cut Off Tool 20k Rpm 36 Cfm

Dynabrade 52431 cut-off wheel tool is ideal for cutting sheet metal, frame rails, clamps & bolts by fitting 4-inch diameter reinforced cut-off wheels (with 3/8-inch centre hole) in its 3/8"-24 spindle. This Dynabrade air tool has a handle that is offset 7 degrees for one-handed control & user comfort.

Working Mechanism:

• Firstly, check all the equipment and mounting accessories for any damage. Wear personal protection equipment.
• Connect the tool to the air power source with inlet pressure below 90 PSIG through a filter-regulator-lubricator unit to prevent unclean / wet air or insufficient lubrication.
• Use a clamping device for holding the workpiece in place without excessively forcing the tool or workpiece.
• Depress the throttle lever in the unit to start the unit. Operate the machine for one minute before the application to determine safe & proper operation. Check that the tool is not running at speeds above the rated RPM (speed) using a tachometer.
• Start the operation on the workpiece after performing the required checks.
• Shut down the tool after every use.

Features:

• Dynabrade 52431 cut-off wheel tool has a 0.7 hp (522W) gearless motor for low maintenance & downtime.
• It consumes 36 SCFM air at a maximum pressure of 90 PSIG (6.2 bar).
• This Dynabrade tool has a safety-lock lever for preventing accidental operation.
• It has a rear exhaust for flushing out spent lubricant or material.

Compatible Accessories:

• Dynabrade 11289 Air Filter-Regulator-Lubricator Systems: These FRL systems regulate air pressure, filter water contaminates and lubricate this pencil grinder.
• Dynabrade 95842 Air Lube: This lubricant prevents the formation of rust or sludge.
• Dynabrade 95460 Dynaswivel: This airline connector swivels 360 degrees at two locations for improving tool manoeuvrability.
• Dynabrade 96045 Motor Tune-Up Kit: This kit contains assorted parts for maintaining the unit's motor & increasing its operating life.

Standards and Approvals:

• ANSI B186.1
• ANSI B7.1
• OSHA 2206

Frequently Asked Questions:

Q. How much sound does this Dynabrade 52431 cut-off wheel tool produce?

A. Dynabrade 52431 cut-off wheel tool produces a maximum noise of 88 dB(A).

Q. What is the maximum speed of this Dynabrade 52431 cut-off wheel tool?

A. This Dynabrade pneumatic tool has a maximum speed of 20000 RPM.

Q. What size air hose is required for this Dynabrade 52431 cut-off wheel tool?

A. This Dynabrade cut-off tool has a 1/4-inch NPT connection, making it suitable for a 1/4-inch hose.